D7024
Installation and Setup
D7024 Operation and Installation Guide
41740F Page 20 © 2005 Bosch Security Systems
3.0 Installation and Setup
In the shipping box, you should find:
• One D7024 Control/Communicator in static-
resistant bag
• One Enclosure with transformer
• One hardware pack
• One enclosure lock, washer, and keys
• Six End-of-Line (EOL) resistors
The hardware necessary for installing the control panel in
the enclosure is located in the hardware pack.
3.1 Installing the Enclosure
Using the enclosure as a template, mark the top mounting
holes on the mounting surface (see Figure 3).
Pre-start the mounting screws (not supplied) for these two
holes. Slide the enclosure onto these screws so that the
screws move up into the thinner section of the holes.
Tighten the screws.
Screw in the remaining two screws in either set of bottom
mounting holes.
Knock out the desired wire entrances on the enclosure.
ground
wire
Mounting Holes
Mounting Holes
control panel location
transformer
retainer holes
for standoffs
retainer holes
for support posts
Figure 3: Enclosure Installation
3.2 Installing the Control/Communicator
The D7024 control board is static sensitive. Make sure you touch ground before handling the
control board. This will discharge any static electricity in your body. For example, run the ground
wire to the enclosure before handling the control board. Continue touching the enclosure while
installing the control board.
Insert the three support posts in the retainer holes on
enclosure (see Figures 3 and 4).
Press the 1/8" nylon standoffs (P/N: 30503) into the
retainer holes (see Figures 3 and 4).
Slide the top of the control into the retainer tabs (the slots
under the top of the frame). Once in the retainer tabs, the
control will rest on the posts.
Secure the bottom of the control by screwing the two
bottom corners through the support posts and through to
the control retainer holes (see Figure 4).
Once the control board is installed, be sure to connect the
supplied ground wire between the door and the enclosure
using the supplied nuts. A second ground wire is provided
for connecting AC power ground. Both grounds connect to
the stud in the enclosure to the left of the circuit board.
Support Post Assembly
retainer hole
in enclosure
support post
corner of
circuit board
=
1/8” nylon standoff
retainer holes
Figure 4: Standoff and Support Post Installation
