&0 ,++" 111"/6- (#/,*1,,)"#,/"*(&+$+600"*)6
!'201*"+10,/ %+$&+$ "00,/&"0. Such preventive safety measures
reduce the risk of starting the tool accidentally.
-10-
00"*)6
"#,/"20&+$$/&+!&+$4%"")
-,&+1,/ ,+"" "/1&+
1%1&10*5&*2*0#",-"/1&+$0-""!&0
+,1"5 ""!"!61%"+*"-)1"0-""!,#
1%"$/&+!"/ Do not exceed the recom mended
wheel point or cone diameter of 2 inches.
"02/"1%11%"!&*"1"/,#
1%"0%+(&01%"0*"0&7"
01%"&+0&!"!&*"1"/,#1%" ,))"1
To prevent damage to collet,
avoid excessive tightening of
the collet nut when there is no accessory inserted.
Only use properly fitting and undamaged
open-end 19 mm wrenches.
1. Place a (19 mm) open-end wrench onto the
spindle to prevent the spindle from rotating
(Fig. 2).
2. Hold wrench in place and rotate collet nut
counter-clockwise with another (19 mm)
open-end wrench.
3. Insert three fourths of shank of accessory
into the collet and securely tighten collet nut
clockwise.
Repeat steps 1 and 2 of above and remove
accessory.
!
WARNING
!
WARNING
!
WARNING
!
CAUTION
