145
E
Additional
Information
Memory Card Operations
Cause and/or what to do about it
• It is not turned the right way ( 115).
Turn it the right way and try inserting again.
• Turn the camcorder’s power off and back on
again and remove and reinsert the card. If the
mark continues to flash, format the memory
card.
• The camcorder is not set to CARD CAMERA or
CARD PLAY (VCR) mode ( 118, 120).
• The memory card is not inserted ( 115).
• You are using an SD Memory Card and it is set
for erasure prevention. Change the position of
the protect switch.
• The memory card is full. Erase images ( 122)
or insert a new memory card.
• The power source is not properly connected, or
the battery pack is exhausted or not properly
attached ( 16-17, 137).
• The function cannot be used in that recording
program ( 52).
• The memory card is not loaded ( 115).
• You are using an SD Memory Card and it is set for
erasure prevention. Change the position of the
protect switch.
• The memory card is full. Erase images ( 122)
or insert a new memory card.
• You have reached the maximum file number. Set
the file numbering to RESET through the menu
( 117) and insert a new memory card.
• You are using an unformatted memory card.
Format the card ( 133).
• The image is protected ( 122).
• You are using an SD Memory Card and it is set
for erasure prevention. Change the position of
the protect switch.
Problem
? The memory card will not insert.
? The mark flashes red in the display
even though a memory card has been
inserted.
? Nothing happens when I press the
buttons.
? The PHOTO button does not work.
? The image cannot be erased.
