Setting Item Description, Instructions
Adjust
Printer
Feed
Priori-
ty
Adj.
Quali-
ty
Auto(OtherPaper) The printer prints and reads a test pattern for auto-
matic adjustment of the feed amount. Note that this
function takes more time and consumes more ink
than Auto(GenuinePpr). (See "Automatic Banding
Adjustment (Adj. Quality).")
→P.772
Manual Use this mode with highly transparent media or other
paper for which Auto(GenuinePpr) or Auto(Other-
Paper) cannot be used.
Print a test pattern for adjustment of the feed amount
based on the type of paper. (See "Manual Banding
Adjustment (Adj. Quality).") →P.774
Adjust
Length
Ad-
just-
ment-
Print
A:High Print a test pattern for particular types of paper to
compensate for paper stretching or shrinkage, after
which you enter the amount of adjustment. (See
"Adjusting Line Length (Adjust Length).")
→P.776
B:Standard/
Draft
Chang
e Set-
tings
A:High Displayed when you have selected Feed Priority >
Adj. Priority > Print Length.
Adjustment relative to the amount of stretching or
shrinkage of the current paper.
Enter either the adjustment results from Adjust-
mentPrint or the discrepancy that you measured (as
a percentage).
For paper that tends to stretch, increase the feed
amount by choosing a higher adjustment value. For
paper that tends to shrink, decrease the feed amount
by choosing a lower adjustment value.
B:Standard/
Draft
Adj Far Ed Feed Choose Yes to adjust the feed amount for the trailing
edge.
Cali-
bra-
tion
Auto Adjust Choose Yes for automatic adjustment of the adjust-
ment value after a test pattern for color calibration is
printed. The new color calibration adjustment value
is applied in all print jobs.
Calibration Log Check the date when color calibration was executed,
as well as the type of paper used, as shown on the
Display Screen.
Use Adj. Value Choose Disabled > OK if you prefer not to apply the
color calibration adjustment value in print jobs. The
printer driver settings will be used instead.
Choose Enabled > OK to apply the color calibration
adjustment value in print jobs. However, printer driv-
er settings are given priority.
Return Defaults Clear the color calibration adjustment value and the
execution log.
Main-
te-
nance
Head Cleaning Clean the Printhead. (See "Cleaning the Print-
head.") →P.910
Choose Head Cleaning A if printing is faint, oddly
colored, or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all,
or if printing is not improved by Head Cleaning A.
Nozzle Check Print a test pattern to check the nozzles.
Printer Parts
>
Control Panel
>
Menu Settings iPF6300
8
842
