your device referring to its instruction
manual.
If the error is still not resolved, check if you
can print another photograph.
Check the device connected to the machine.
Printing photos directly is possible only with
a PictBridge compliant device.
E, 1, 3
Ink level cannot be detected.
Ink may have run out.
The function for detecting the remaining ink level
will be disabled since the ink level cannot be
correctly detected.
If you want to continue printing without this
function, press the
Stop/Reset
button for at least
5 seconds.
Canon recommends to use new genuine
Canon cartridges in order to obtain optimum
qualities.
Please be advised that Canon shall not be
liable for any malfunction or trouble caused by
continuation of printing under the ink out
condition.
E, 1, 4
The FINE Cartridge cannot
be recognized.
The FINE Cartridge may not be compatible with
this machine.
Install the appropriate FINE Cartridge.
Routine Maintenance
E, 1, 5
The FINE Cartridge cannot
be recognized.
The FINE Cartridge may not be installed
properly.
Open the Scanning Unit (Cover) and install the
FINE Cartridge properly.
Routine Maintenance
E, 1, 6
Ink has run out.
Ink has run out.
Replace the ink cartridge and close the
Scanning Unit (Cover).
If printing is in progress and you want to
continue printing, press the
Stop/Reset
button
for at least 5 seconds with the ink cartridge
installed. Then printing can continue under the
ink out condition.
The function for detecting the remaining ink level
will be disabled.
Replace the empty ink cartridge immediately
after the printing. The resulting print quality is
not satisfactory, if printing is continued under the
ink out condition.
E, 1, 9
(MP240 series)
PictBridge compliant device
is connected via a USB hub.
If a PictBridge compliant device is connected via
a USB hub, remove the hub and connect it
directly to the machine.
E, 3, 0
The size of the original
cannot be correctly detected
or the document is too
small when the Fit-to-Page
copying is selected.
Make sure that the original meets the
requirements and is correctly loaded on the
Platen Glass.
Check the position and direction of the
original loaded on the Platen Glass.
E, 3, 1
The machine is not
connected with the
computer.
Connect the machine and the computer with a
USB cable.
E, 3, 2
E, 3, 3
(MP260 series)
Scanning the Photo Index
Sheet has failed.
Make sure that the Photo Index Sheet is set
in the correct position and orientation on the
Platen Glass.
Make sure that all required circles on the
Photo Index Sheet are filled in.
E, 3, 4
E, 3, 6
No DPOF information./
Unable to scan images on
There is no image data saved on the
memory card that can be read by this
Page 531 of 628 pagesAn Error Code Is Displayed on the LED
