120
4. Connect the camcorder to the printer using the cable.
• appears and changes to
,
or when the printer is properly
connected to the camcorder. (Does not appear with movies, or still images that cannot
be played back with the camcorder.)
• The (print/share) button lights up and the current print setting will be displayed
for approx. 6 seconds.
❍ If continues to flash (for more than 1 minute) or if , or
does not appear, the camcorder is not correctly connected to the
printer. In such case, disconnect the cable from camcorder and printer, turn off
camcorder and printer, turn both back on and reconnect the camcorder to the
printer.
❍ Do not connect the camcorder to a printer when the camcorder is set to
NETWORK mode.
❍ Refer to the instruction manual of each printer for information on which
interface cable to use with the camcorder.
The Canon CP-Printers CP-10 and CP-100 are supplied with two direct
interface cables. Use the cable with the USB logo on the connector (DIF-100).
❍ We recommend powering the camcorder from a household power source.
❍ Refer also to the instruction manual of the respective printer.
❍ The print setting menu may differ slightly depending on the connected printer.
Printing
1. Select the still image you wish to print with the
CARD +/– button.
2. Press the (print/share) button.
• Printing starts. The button flashes and glows steadily
when printing is complete.
• If you wish to continue printing, select another still image with
the CARD +/– button.
❍ Observe the following precautions during printing, otherwise printing may not
be performed correctly.
- Do not turn off the camcorder or the printer.
- Do not change the position of the TAPE/CARD switch.
- Do not detach the cable.
- Do not open the memory card cover or remove the memory card.
❍ Images not recorded with this camcorder, uploaded from a computer, edited
on a computer and images whose file names have been changed may not be
printed correctly.
