A SERVICE OF

logo

Open as PDF
next previous
CHAPTER 4 IMAGE FORMATION SYSTEM
COPYRIGHT
©
1999 CANON INC. CANON PC800s/900s REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
4-27
Figure 4-204
Figure 4-205
Figure 4-206
[3]
[4]
[5]
Lamp PCBs
7) Open the machine’s top unit farther, and
hold it in place using the handle of a
screwdriver (about 30 mm in diameter).
8) Remove the four screws [3], and discon-
nect the connector [4]; then, detach the
blanking exposure unit. [5].
Caution:
When mounting the blanking exposure
unit, check to make sure that the blank-
ing exposure unit PCBs are at the ex-
treme ends and that the lens is positioned
at the farthest left (141% position).