64
Using the Wind Screen
With the supplied microphone (only), you can reduce the sound of wind recorded from the front
microphone.
Open the menu and select [AUDIO SETUP]. Select [WIND SCREEN], select a setting
option and close the menu.
Recording on Channels 1 and 2
Select the audio input from FRONT MIC (supplied microphone), AUDIO1 (RCA terminals) or REAR
(XLR terminals). Refer also to the Audio Block Diagram ( 157).
When Using the Front Microphone
Set the INPUT SELECT switch to FRONT MIC.
• You can select the microphone setting with the STEREO/MONO switch on the microphone itself. In the
MONO position, the same monaural audio signal will be recorded on channels 1 and 2.
• If necessary, turn on the microphone attenuator (20 dB) by setting the FRONT MIC ATT. switch to ATT.
When Connecting to the RCA terminals of AUDIO1 (Line-in Recording)
1. Connect the device to the RCA terminals of AUDIO1.
2. Set the INPUT SELECT switch to AUDIO1.
MENU
( 31)
AUDIO SETUP WIND SCREEN•••ON
