Airtronics RD6000 transmitter setting screen
Throttle
Trim
Rudder
Trim
Model #
Elevator
Trim
Aileron
Trim
Flight
Mode
This is an addendum instruction provided for your convenience. These
instructions are specially designed for Hummingbird Elite CP owners who
want a step-by-step procedure for the Airtronics RD6000.
Indicated voltage will vary based on the charge status of the battery.
Main Screen
Channel Indicator
Frequency
Type
Battery can be removed from it’s case for replacement.
The charge jack can be found on
the right hand side of the transmit-
ter. 110V wall type charger is
included with radio.
After your system is fully charged flip the
power switch and begin following the
directions on the following page.
Use the button pad to navigate to each screen
and make step by step changes to configure
the transmitter for the CP Elite.
First please refer to the instruction manual
provided with your radio system.
Airtronics RD6000 transmitter
button pad.
Resetting the Airtronics
RD6000 transmitter
Use these
steps if you
feel you have
made a
mistake or you
are entering a
configuration
for a new
model. Then
proceed to
step 1.
STW etc Screen
Press
Down x 12
TYP acro Screen
Press
Right x 1
TYP heli confirm
Press x 1
inc+/yes
Finished
Press x 3
end
Home acro
Screen
Press
Left x 1
First please refer to the instruction manual provided with your radio system.
*Actual EPA %
values may vary
depending on
equipment used.
