OPERATION
iiVtPORTANT SAFETY INSTRUCTnONS
To reduce the risk of SEVERE iNJURY or DEATH:
I. READANDFOLLOWALLWARNINGSAND INSTRUCTIONS.
2 ALWAYSkeepremotecontrols outof reachof children
NEVERpermit childrento operateor playwith garage
control consolepushbuttonsor remotecontrols
3. ONLYactivategaragedoor whenit canbeseenclearly,it is
properlyadjusted,andthereare no obstructionsto door
travel.
4 ALWAYSkeepgaragedoor in sight until completelyclosed
NOONESHOULDCROSSTHEPATHOFTHEMOVING
DOOR.
5..NOONESHOULDGOUNDERA STOPPED,PARTIALLY
OPENEDDOOR
6. if possible,useemergencyreleasehandleto disengage
trolley ONLYwhengaragedoor is CLOSEDWeakor broken
springs or unbalanceddoor couldresult in an opendoor
falling rapidlyand/or unexpectedly_
7 NEVERuseemergencyreleasehandleunlessgarage
doorwayisclearof personsand obstructions..
8. NEVERusehandleto pull garagedoor openor closed.If
ropeknot becomesuntied,youcouldfall
9 tf onecontrol (force or travellimits) is adjusted,the other
control mayalsoneedadjustment..
10..After ANYadjustmentsaremade,the safetyreversal
systemMUSTbetested..
11. SafetyreversalsystemMUSTbetestedeverymonth
Garagedoor MUSTreverseon contactwith 1-I/2" high
(3.8cm) object (ora 2x4laidfiat) on thefloor
12 ALWAYSKEEPGARAGEDOORPROPERLYBALANCED
(seepage3). Animproperiy balanceddoor maynot
reversewhenrequiredand couldresult in SEVEREINJURY
or DEATH.
13. ALL repairsto cables,springassembliesand other
hardware,ALLof whichareunderEXTREMEtension,
MUSTbe madebya traineddoor systemstechnician.
I4 ToavoidSERIOUSPERSONALINJURYor DEATHfrom
electrocution,disconnectALLelectricandbattery power
BEFOREperformingANYserviceor maintenance.
SAVETHESEnNSTRUCTIONS.
Using Your Garage Door Opener
Your Security+ _opener and hand-held remote control
have been factory-set to a matching code which changes
with each use, randomly accessing over 100 billion new
codes.. Your opener will operate with up to eight
Security,__ remote controls and one Security'l -_ Keyless
Entry System. If you purchase a new remote, or if you
wish to deactivate any remote, follow the instructions in
the Programming section..
Activate your opener with any of the following:
• The hand-hold Remote Control: Hold the large push
button down until the door starts to move..
• The wall-mounted control console: Hold the push
button or bar down until the door starts to move.
• The Keyless Entry (see Accessories):' If provided with
your garage door opener, it must be programmed
before use..See Programming.
When the opener is activated (with the safety
reversing sensor correctly installed and aligned)
1.If open, the door will close.. If closed, it wilt open.
2 If closing, the door will reverse..
3. If opening, the door will stop°
4..If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.. If the
obstruction interrupts the sensor beam, the opener
lights will blink for five seconds.
6_If obstructed while opening, the door witl stop.
7. If fully open, the door will not close when the beam Es
broken.. The sensor has no effect in the opening cycle,
If the sensor is not installed, or is misaligned, the door
won't close from a hand-hefd remote. However, you can
close the door with the control console, the Outside
Keylock, or Keytess Entry, if.you activate them until down
travel is complete_ tf you release them too soon, the door
will reverse..
The opener lights wilt turn on under the following
conditions: when the opener is initiallyplugged in;when
power is restored after interruption;when the opener is
activated..
They willturn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the
Control Console is activated. Bulb size is 100 watts
maximum.
Security*_ light feature: Lights will also turn on when
someone walks through the open garage door..With a
Motion Detecting Door Control Console, this feature may
be turned off as follows: With the opener lights off, press
and hold the light button for 10 seconds, until the light
goes on, then off again.,To restore this feature, start with
the opener lights on, then press and hold the light button
for 10 seconds until the light goes off, then on again
31
