Upper Knob (PWR-VOL)
-
The upper knob has these two functions:
Push it to switch
the
system on and off.
Turn it to control the volume.
SCV
(Speed Compensated Volume)
-
Move the control ring behind the
upper knob clockwise
to
adjust the Speed Compensated Volume feature. As
you
drive, this feature increases the volume
to
overcome noise at any
particular speed. Each clockwise position
on
the control ring allows more
compensation and at
a
faster rate.
AM/FM
-
Press this button to switch between
AM,
FMl
and
FM2.
The
display will
show
what mode the receiver is
in.
RCL
(Recall)
-
Press this button
to
change between the clock and the radio
station frequency displayed when the radio is
on.
Also, press this button
to
display the time when
the
ignition is off.
TUNE
-
Press lightly on the TUNE button to release it from its stored
position. Rotate the knob clockwise
to
increase frequency and
counterclockwise
to
decrease radio frequency. When done, press the knob
again to return it to its stored position.
Pushbuttons
-
The
six
pushbuttons let
you
return
to
favorite stations. To
set the pushbuttons for up
to
18
favorite stations
(6
AM,
6
FM1
and
6
FM2):
1.
Tune in the desired station.
2.
Press
AUTO
TONE
to select the best setting for the type of station
chosen.
3.
Press and hold one
of
the
pushbuttons until sound returns
(approximately two seconds). Whenever
you
press that button, the
preset station will return.
Repeat these steps for each pushbutton.
SEEK
-
Press
SEEK
to cause the receiver to seek the
next
higher
station.
Press
4
SEEK
to
cause
the
receiver to seek the next lower station.
SCAN
-
Press and hold the center
of
the SEEK button to momentarily hear
each available station. Release the button when SCAN appears in the
display. The receiver will
continue
to scan and momentarily stop at each
station until you press the center of the
SEEK
button again.
P.
SCAN (Preset Scan)
-
Press this button to scan each preset pushbutton
station. The receiver will continue to scan and momentarily stop at each
station until you press either P.
SCAN
again or
one
of
the
six
pushbuttons.
The AUTO
SCAN
setting for that preset button will also return. The
pushbutton number (Pl-P6) will appear momentarily just before frequency
is
displayed.
3-20
