CRADLEPOINT MBR95 | USER MANUAL Firmware ver. 3.2.4
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 78
7.1 Connection Manager
The router can establish an uplink via the Ethernet WAN port, WiFi as WAN, or modems plugged into a modem port. If the
primary WAN connection fails the router will automatically attempt to bring up a new link on another device. This feature is
called failover. If Load Balance is enabled, multiple WAN devices may be plugged in and each may establish a link.
7.1.1 WAN Interfaces
This is a list of the available interfaces used to
access the internet. You can enable, stop, or start
devices from this section. By using the priority
arrows (the arrows in the red boxes; these show if
you have more than one available interface), you
can set the interface the router uses by default and
the order that it allows failover. To configure a
specific interface, use the settings page for that type
of interface (e.g. Ethernet Settings page for wired
connections).
