6
4. Press reset button on GFI plug.
5. Turn the thermostat knob fully in a clockwise direction to the maximum setting.
6. Turn on the Heater.
7. When the desired room
temperature has been
reached, turn the
thermostat knob counter
clockwise until you hear a
click. The heater will keep
the air temperature in the
room at the set temperature
by switching on and off automatically.
8. When set at minimum (fully counter-clockwise) position (depending on the size of
the room) the heater will maintain the temperature above freezing.
9. The indicator light will stay on to let the user know that the heater is connected
to an electrical power source.
OVERHEAT PROTECTION
The heater has an internal, over-heating safety device which automatically switches the
heater off if an over-heat situation is detected. If this should occur, unplug the
appliance and wait until the unit cools off. Once the unit has fully cooled, you can switch
it on again.
ANTI-FREEZING SAFETY LEVEL
In order to avoid the temperature dropping under approximately 32 degrees Fahrenheit
(for instance, when you are absent for a long time), you can turn the thermostat knob to
the anti-freezing safety level at the “Minimum” position.
CAUTION:
Always be sure that the heater is switched OFF, unplugged and completely
cooled before cleaning or attempting to store the item. Do not immerse heater
in water or allow water to drip into the interior of the heater, as this could
create an electric shock hazard.
CARE AND CLEANING
1. Clean the outside of the heater by wiping with a damp cloth and buff with a dry
cloth.
2. DO NOT use any detergents or abrasives and do not allow any water to enter the
heater.
Please Note: Regardless of the type of heating system setup, always install and
maintain at least one smoke detector in good working condition on each floor of your
home. Periodically check and/or replace the battery in your smoke detector with a fresh
battery.
STORING
Allow the appliance to cool completely before storing. Store the appliance in a dry
location. Do not place any heavy items on top of appliance during storage as this may
result in possible damage of appliance. Store the cord in a clean, dry location away