4
Control and Monitoring
This chapter contains the commands to configure and monitor the system, including Telnet, file transfer
protocol (FTP), and trivial file transfer protocol (TFTP).
NOTE: Starting in version 9.0.2.0, the enable xfp-power-updates command was deprecated for
the S6000 This command replaces the enable optic-info-update interval command to
update information on temperature and power monitoring in the simple network management
protocol (SNMP) management information base (MIB).
banner exec
Configure a message that is displayed when your enter EXEC mode.
Syntax
banner exec c line c
To delete a banner, use the no banner exec command.
Parameters
c Enter the keywords banner exec, then enter a character
delineator, represented here by the letter c. Press ENTER.
line Enter a text string for your banner message ending the
message with your delineator. In the following example, the
delineator is a percent character (%); the banner message is
“testing, testing”.
Defaults No banner is displayed.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Control and Monitoring
89
