10
Disconnect tool from air supply before adjusting,
clearing jams, servicing, relocating and during
non-operation.
Never place your hand, or any part of your body, in
the fastener discharge area of the tool when air
supply is connected to the tool. Serious personal
injury may occur.
LOADING THE TOOL
OPERATING THE TOOL
NOTE
Check and replace any damaged or worn compo-
nents on the tool. The safety warning labels on the tool
must also be replaced if they are not legible.
Disconnect tool from air supply before adjusting,
clearing jams, servicing, loading, relocating and dur-
ing non-operation.
Protect your eyes and ears. Wear Z87 safety
glasses with side shields. Wear hearing protection.
Employers and users are responsible for ensuring
the user or anyone near the tool wear this safety
protection.
READ THIS MANUAL AND UNDERSTAND ALL
SAFETY WARNINGS AND INSTRUCTIONS BE-
FORE OPERATING TOOL.
NOTE
Use DeVilbiss Air Power fasteners or equivalent for
proper performance of tool. See page 15 for
fastener information.
1. Disconnect air hose.
2. Pull up on the Stopper #56. Pull back on Reel Plate #50
to open magazine. (Items 50 & 56 - Page 13)
3. Insert a stick of fasteners into the magazine. Make
sure the pointed ends of the fasteners are resting on the
bottom edge of the magazine. Also make sure fasteners
are not dirty or damaged. Use DeVilbiss fasteners or
equivalent for proper fastener performance.
4. Push the magazine cover forward until the reel plate
catches under stopper.
Handle the tool carefully. Respect the tool as a
working implement and always assume the tool
contains fasteners and is ready to operate.
a. Never use the tool as a toy and engage in horse-
play.
b. Never aim or point the tool at anyone. The tool
may contain fasteners.
c. Always keep people and animals at a safe dis-
tance from the work area in case of accidental
discharge of fasteners.
d. Never pull the trigger unless the nose of the tool
is against the work surface.
e. Do not pull the trigger or depress the contact trip
when loading the Tool.
