Service
Manual
PageEdition
Type
30. Motor
30
G108
2
1
3
4
Motor runs slowly
The motor is probably only running on two phases
(applies to three phase machines).
• Check that the voltage supply to the motor is
correct.
• Remove the quick connector and check for open
motor windings or a short circuit.
Motor is very noisy or stalls
• Faulty bearings — replace the motor or bearing
(for motor replacement, see below).
Removing the motor
1 Remove the drain valve from the shaft by lifting it
up.
2 Remove the tensioner.
3 Remove the quick connector to the motor.
4 Unscrew the two screws which hold the shaft in
place. Pull the shaft towards the front of the
machine so that the bracket guide pins release.
5 Remove the motor from the shaft. Use soap
solution if the rubber bushings are resistant.
83
9002
4
Fig.
4
