PictureMate Deluxe Viewer Edition
10 - PictureMate Deluxe Viewer Edition 4/05
4. Push down the top of the paper support and close it against
PictureMate. Then lower the photo viewer screen and close
the output tray.
5. Disconnect the power cord and any connected USB cable
from the back of PictureMate.
6. Pack PictureMate and its power cable (both parts) into the
box that PictureMate came in, or in the optional
PictureMate Carrying Case.
Caution: Make sure the photo cartridge is installed before
transporting. Don’t place PictureMate on its side or upside
down, or ink may leak.
Note: If your prints don’t look as good after PictureMate has
been moved, try aligning the print head (see page 9).
Using the Optional Battery
With a fully charged battery, you can print from 50 to 80
photos. Follow these steps to install the optional battery.
1. Turn the printer off and unplug the AC adapter.
2. Open the battery cover on the back of the printer.
3. Slide in the battery as shown until it clicks into place:
4. Make sure the battery is pushed in all the way so that it
locks into place as shown:
5. Close the battery cover.
After you install the battery, you need to charge it by
connecting the AC adapter and plugging in the printer. It
takes about 2 hours to fully charge the battery when
PictureMate is off, and longer when it is in use.
Related Documentation
CPD-19365 PictureMate Start Here
CPD-19367 Using PictureMate Without a Computer
book
CPD-19430 Using PictureMate With a Computer book
CPD-19366 PictureMate Deluxe Viewer Edition
CD-ROM with electronic User’s Guide
Lock
