Format
ICE CONTROL SOFTWARE ICS62XX
VIII-60 EPSON S1C62 FAMILY
DEVELOPMENT TOOL REFERENCE MANUAL
Function
G GO TARGET PROGRAM
#G
#G,<address >
#G,R
This instruction runs the target program. When a break condition is detected, program
execution is halted and the break status is displayed to complete the instruction.
■ Setting the Starting Address
(1) When an <address> is entered, the run starts from that address.
(2) With an R setting the evaluation board CPU is reset, and the run starts from the reset
address 0100.
(3) When the <address> and R setting are defaulted, the run starts from the current
address (PC which displays the status during the previous break).
When G is entered after power on, the run starts from address 0100, but the
evaluation board CPU is not reset.
■ Break Mode and Break Condition
Note: Refer to Section 2.3.2, "Break mode and break function" for more information on the
break mode.
1
2
3
Break enable mode
& break stop mode
Break enable mode
& break trace mode
BSYN mode
& break stop mode
* Reset switch
* Break switch
* Break set commands
(BA, BD, BR, BM)
* ESC input
* Reset switch
* Break switch
* ESC input
* Reset switch
* Break switch
* ESC input
Break mode (note) Break condition CommentsItem
Mode at power on.
When the break condition and evaluation
board CPU executed cycle coincide,
a pulse is output to the SYNC pin.
When the break condition and evaluation
board CPU executed cycle coincide,
the bleak status alone is displayed and
the GO command is restarted.
