-- 1 5 --cmek2de1
CONTROL PANEL AND CONNECTIONS
1. Cooling water connections
(only --883 model).
2. Gas connection.
3. Connector for control cable from the
power unit.
4. Connector for welding current cable from
the power unit.
5. Potentiometer, wire feed speed 1. 9 -- 20
meter per minute.
6. Cooling water connections to/from the
welding gun (only --883 model).
7. Strap securing points. The strap must be
used to secure the wire feed unit to the
power unit during transport.
8. Hole for fitting wire liner from the ES AB
Marathon Pac.
9. Welding gun connector.
10. Selector switch, 2/4--stroke mode.
11. Selector switch, creep start On/Off.
12. Potentiometer, burn --back time, 0 -- 0.5 seconds.
13. Brake hub.
The hub is adjusted when delivered, if readjustment is required, follow the instructions
below.
Adjust the braking power by means of the two screws (springs) inside the hub.
Turn the adjustment screws clockwise to reduce the braking power.
Adjust the brake hub so that wire is slightly slack when wire feed stops.
S = Adjustment screws
cmek0p05
