HD200-en-GB_V2.3 4/15
6
Setup Option Mode
Entering and Changing a Setup Options
1. Press and hold the Setup button for 3 seconds to enter the Setup mode.
“SETUP” will appear in the upper right-hand corner of the LCD
2. Press
▲ or ▼to scroll to the desired setup option
3. Press ENTER to begin editing the selected option.
4. Press
▲or ▼ to change to the desired setting.
5. Press ENTER to store the new setting in memory and step to the next option
6. Press and hold the Setup button for 3 seconds to exit the Setup mode
Note: Setup is disabled in MIN MAX/AVG or REC mode.
Offset (for T1, T2, or T3)
The primary display shows the actual temperature plus the offset; the secondary display shows only
the offset value. Individual offsets for T1, T2 and T3 can be stored for later recall.
Auto Power Off mode (SLP)
1. The default mode is Sleep Mode ON (the meter will automatically shut off after 20 minutes of
inactivity).
2. Press
▲ or ▼ to scroll to the “SLP” page.
3. Press ENTER to show the current setting (ON or OFF).
4. Press
▲ or ▼ to change the setting. Press ENTER to store the new setting in memory. On
(sleep mode on) or 0FF (sleep mode off).
Time Setting (tiE)
1. Display the time. The primary display shows the year. The secondary display shows the month
and the day, the third display shows the hours and minutes. Press ENTER to exit the time
setting option without making changes.
2. Set the time. The order is year--- month ----day---- hours--- minutes. Use °C·°F·°K to select a
digit group. Use the
▲ or ▼ buttons to change the setting. Press ENTER to store the new
setting in memory.
Sample Rate (rAt)
The third display shows the datalogger sample rate. The default sample rate is 1 second. The third
display show “0 0 0 1”. The order is minutes/seconds. Press °C·°F·°K to toggle between minutes
and seconds. The flashing digits indicate the digits ready to be edited. Press
▲ or ▼ to change the
sample rate. Press ENTER to store the new setting in memory.
Erase the Datalogger Memory (CLR)
To clear the memory, enter the CLR setup mode, press
▲ or ▼ until the display shows the
confirmation screen “SURE YES” and press ENTER to clear the memory.
Display Option Description
T1 T1 Offset Adjust T! offset value
T2 T2 Offset Adjust T2 offset value
T3 T3 Offset Adjust T3 offset value
SLP Sleep Mode ON (mode on) or OFF (sleep mode off)
tiE Time setting Check the time or Set the time
rAt Sample rate Set the datalogging sample interval
CLR Clear Clear the datalogger memory
