
PoleVault Systems Installation • Installation — Stage 5
2-25
Installation — Stage Five, cont’d
2. Congure the system — Global
Configurator
a. Download and install Extron’s Global Congurator (GC)
configuration program (available at www.extron.com) on
the laptop or PC
b. Ensure the PC and the MLC 104 IP Plus are connected to
the LAN.
N
If this is not possible, connect a 2.5 mm TRS
configuration cable (part # 70-335-01) to the PC
and to the front panel configuration port of
the MLC 104 IP Plus.
c. Launch the Global Congurator program. Click on Help,
then Contents (or press F1).
d. Select the MLC 104 IP Plus/PoleVault system from the
drop-down box. Follow the instructions on the help
page.
e. To move to the next page (as shown in the yellow box,
figure 2e), click the NEXT button above the drop-down
box. Repeat as needed, following the instructions on
the pages to congure the MLC 104 IP Plus, as needed.
Load Global Configurator software
Launch Global Configurator
Select MLC 104 IP Plus/PoleVault System
Configure the MLC 104 IP Plus