STEP 1 – Foot Tube Assembly
Remove the two Carriage Bolts, Washers and Nylon
Nuts from both the Front Foot Tube with Rollers and
the Rear Foot Tube with Caps.
Align the Rear Foot Tube with the rear of the Main
Frame Assembly. Make sure the square holes in the
Rear Foot Tube are on the outside. Insert Bolt
through the Rear Foot Tube and Main Frame
Assembly. Secure with Washers and Nuts you
just removed. Tighten with
the Wrench provided.
Repeat on the front of the
unit using the Front Foot
Tube with Rollers.
1
a) Place the Seat Carriage Slider on the
Back Rest with the Seat Carriage
Bushing toward the top of the Back
Rest. Secure with the Phillips Bolts,
Washers and Hex Nuts from your
Fastener Pack. Tighten bolts with the
Wrench provided.
b) Place the Seat Cushion on a flat surface. Position the Seat
Carriage with the wheels up as shown. Secure with Phillips
Bolts and Washers. Tighten with the Wrench provided. Turn
Assembly over.
c) Remove the Bolts, Washers and Nuts with Nut Caps from
the Rear Handlebar (the ones with the Pulse Sensors).
Position the Handlebar into the notch on the Seat
Carriage, making sure the wires are facing down and
the Pulse Sensors are facing up. Replace the Bolts,
Washers and Nuts with Nut Caps you just removed.
Tighten with the Wrench provided.
d) Slide the Back Rest
onto the Seat
Carriage until it
clicks into an
adjustment hole.
Make sure the
wider part of the
Back Rest is toward
the Seat Cushion.
Tighten the
Adjustment Knob.
