
..--....
The Problem Solver(continued)
PROBLEM
POSSIBLE CAUSEAND REMEDY
WATERWON’T
. Makesuredrainhoseisnotkinked,
DRAIN
● Top of drain outlet should be less than 8 ft. above floor.
WATERLEAKS
● Make sure hose connections are tight at faucets.
● Make sure end of drain hose is correctly inserted in and secured to drain
facility.
WASHER
● Make sure washer is level and fhrn to the floor with rubber foot pads in
IS NOISY
place and front jam nuts tight. See your Installation Instructions.
● A sharp distinctive sound will be heard at the end of each spin period as the
motor stops and the spin brake inside the transmission “locks in? This
sound is normal.
● when usingthesP~scRuBBER C’ycle,a sharpdistinctive sound will be
heard soon after agitation begins. This is the sound of the water recirculation
system cutting off to keep the concentrated detergent solution in the Mini-
Basket tub.
● Heavily unbalanced loads can cause the washer to vibrate excessively during
spin, and may cause it to move from its original position. In extreme cases,
(usually occurs when washing a single, heavy item or a small load when
water level is set higher than necessary) the spin basket may strike the outer
tub, creating aloud but harmless noise. Tocorrect, open the lid and
redistribute the load evenly about the wash basket. Close the lid and restart.
WASHER
● Washer nom~ly pausesbetweenwashing steps. ..such as between wash
PAUSES
and spin or between spin and rinse.
IN CYCLE
If you need more help... call, toll free:
The GE Answer Cente@
800.62&2000
consumer information service
28