10
Specifications
Model LP1000
High-Pressure Plunger Pump
Volume ..................................................................................................3.4 GPM (12.8 LPM)
Maximum Discharge Pressure .............................................................14,500 PSI (1000 Bar)
Maximum Inlet Pressure ......................................................................Up to 90 PSIG (1305 Bar)
RPM .....................................................................................................1000
Plunger Diameter ..................................................................................22mm
Stroke ....................................................................................................42mm
Crankcase Oil Capacity ........................................................................118 fl. oz. (3.5 Liters)
Temperature of Pumped Fluids.............................................................Up to 104
o
F (40
o
C)
Inlet Port ...............................................................................................2 x 1/2" BSP
Discharge Ports ....................................................................................2 x 3/8" BSP
Shaft Rotation .......................................................................................Towards fluid end only
Weight ...................................................................................................143 lbs. (65 KG)
LP1000 HORSEPOWER CHART
3.1
HORSEPOWER RATINGS:
The rating shown are the power
requirements for the pump. Gas
engine power outputs must be
approximately twice the pump
power requirements shown above.
We recommend a 1.15 service factor
be specified when selecting an
electric motor as the power source.
To compute specific pump horse-
power requirements, use the Follow-
ing formula:
HP = (GPM X PSI) / 1400
