G1022 Series Contractor Saws
-35-
Pre-Run Check
Test Run
1. Face the table saw and stand to the left of
the blade path.
2. With one finger on the START button and
one finger on the STOP button, turn the saw
on. Be ready to turn it off in case of mishap.
3. Watch and listen to the saw. Note whether
there are any unusual sounds or excessive
vibrations.
SECTION 6: OPERATIONS
Before you begin to use your Model G1022
Series, you should give it a thorough inspection.
While making your inspection, ask yourself the
following questions:
1. Are all the fasteners tight?
2. Is the blade mounted correctly?
3. Is the saw stable?
4. Is it wired properly?
5. Is your electrical system properly config-
ured?
6. Have you checked your work piece for obvi-
ous defects?
7. Are the V-belts properly tensioned and the
pulleys properly aligned?
8. Is the guard assembly installed and func-
tional?
9. Have you checked the saw blade clearance
when it is adjusted to varying angles and
depths?
10. Have you read all warnings and directions
regarding the operation of this machine?
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
