A SERVICE OF

logo

Open as PDF
next previous
EN
Troubleshooting the Printing System
7-69
Wrong Fuser setting
for paper type.
From the Paper Handling Menu on the Control
Panel, change the Fuser Mode setting or choose
another paper type from the printer driver.
Fusing Assembly is
defective. The print
will smear if the
Fusing Assembly is
not heated sufficiently
to bond the toner
image to the paper.
Replace the Fusing Assembly.
The Static Eliminator
is dirty or is not
grounded, allowing a
static charge to
remain on the page.
Clean using the blue cleaning tool or compressed
air. Replace assembly if damaged.
DC Controller is
defective. The DC
Controller regulates
fusing roller
temperature.
If a new Fusing Assembly does not resolve the
problem, replace the DC Controller PCA.
Table 7-28. Toner Specks
Possible Cause Action
Dirt in printer. 1. Print a few more pages to see if the problem
corrects itself.
2. Clean the inside of the printer (page 4-2) or use
the printer’s cleaning page (page 4-4).
Table 7-27. Toner Smear (continued)
Possible Cause Action