2
Kit Contains:
Hypertech Power Tuning Module
Wiring harness (connectors are marked for easy installation)
Hypertech rotary switch assembly
Hypertech mounting bracket (with module attached)
Hypertech switch plate (cable, switch with knob, connector/wire)
Small standard screwdriver
Installation and operation manual (instructions)
#10 Phillips-head screws (2 each)
Retaining plugs (2 each)
Tie-wraps (3 each)
One tube of Boss RTV sealer (0.5 oz.)
You will need the following:
Insulated adjustable wrench
(to tighten battery terminals and switch mounting nut)
Phillips-head screwdriver (for mounting bracket/module)
Standard (flat) screwdriver (for removing fuse panel)
10mm socket or nut-driver (for removing fuse block)
Drill and 1/8”, 3/8” and 1/2” drill bits
(for rotary switch installation)
Diagonal cutters (for removing tie-wrap excess)
