5
ENgLiSh
JABRA BT2010 BLUETOOTH HEADSET
Please note: The lifetime of the battery will be signicantly
reduced if your device is left uncharged for a long period.
We therefore recommend that you recharge your device at
least once a month.
TURNiNg yoUR hEAdSET oN ANd off
• Press the answer/end button until you see a burst of ashes on
the indicator light (LED) to turn your headset on.
• Press and hold
the answer/end button until you see a burst of
ashes on the indicator light (LED) to turn the headset o.
Please note that the LED indicator light turns o after 1 minute to
save battery. Headset is still active, and light will ash again after
tap on the answer/End button or any call activity. To check if the
headset is on, tap the answer/end button once – the LED indicator
light will ash, if the headset is on.
PAiRiNg iT WiTh yoUR PhoNE
Headsets are connected to phones using a procedure called ‘pair-
ing’. By following a few simple steps, a phone can be paired with a
headset in a matter of minutes. (See g. 3)
1. Put the headset in pairing mode
• When you turn on your Jabra BT2010 for the rst time, the
headset will automatically start up on pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the LED is constantly lit.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT2010
• Follow your phone’s instruction guide. First make sure that
Bluetooth is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going to a
‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and select-
ing the option to ‘discover’ or ‘add’ a Bluetooth device.*
