WET VACUUMING
• Remove motor housing by pulling out on the latch-
es located on either side of the dust container.
• Remove the filter bag.
• Place motor housing on top of the dust container
and press down until the latches pop into place.
• Insert hose into the vacuum port.
• Plug in power cord and switch power to ON.
When the dust container is full of liquid, the float ball
will rise to the top and automatically shut off the air
flow. The sound of the motor will become more high
pitched as the suction ceases and the motor works
harder. When this happens, dry off your hands and
feet and shut off the motor immediately. LEAVING
THE MOTOR RUNNING WHEN THE BALL IS IN THE
RAISED POSITION CAN DAMAGE THE WET/DRY
VACUUM/BLOWER.
Empty dust container before continuing.
EMPTYING THE DUST CONTAINER
Always unplug the power cord before emptying the dust
container to prevent injuries from accidental starting.
• Remove motor housing by pulling out on the latches located on either side of
the dust container.
• ALWAYS dispose of container contents wisely. Use proper waste receptacles.
• Clean out dust container thoroughly.
• Replace filter bag.
• Snap motor housing back onto dust container.
BLOWER USE
ALWAYS wear ANSI-approved safety glasses when using
blower. Particles may fly up into eyes and cause permanent damage. Wear
hearing protection if using blower for extended periods. Dust masks are also
recommended when blowing fine material.
OPERATING THE WET/DRY VACUUM/BLOWER
Do not operate the Wet/Dry Vacuum/Blower in areas where flammable gases
or explosive dust are present. This will reduce the risk of fire or explosion.
Do not vacuum flammable or combustible liquids or hot ashes.
To reduce the health hazards from vapors or dust, DO NOT vacuum toxic
materials.
DRY VACUUMING
• Remove motor housing by pulling out on the
latches located on either side of the dust
container.
• Make sure the filter bag is dry. A wet filter
bag will clog if used to vacuum dry material.
• Check that the filter bag is firmly attached to
the filter basket. Make sure the rubber band
is as close to the cover as possible. Gaps will
allow vacuumed material to blow back out
through the blower hole.
• Place motor housing on top of the dust
container and press down until the
latches pop into place.
9
• Insert hose into the vacuum port.
• Plug in power cord and switch
power to ON.
• When vacuuming large amounts
of debris or very fine dust, empty
the dust container and filter bag
frequently.
• When vacuuming is completed,
turn the switch OFF and unplug
the power cord.
