A SERVICE OF

logo

16142-40900319 • 23
A B
C
FE
D
Sideburner
ƒ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws holding
sideburner in place. (A). Note: Do not loosen electrode screw.
ƒ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
ƒ Insert valve stem through hole in fascia. (D) Attach bezel to fascia and valve face with previously
removed 2 screws.
Attach bezel with black mark facing up (E).
ƒ Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (F)
ƒ Push control knob onto sideburner valve stem. (G)
ƒ Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner
grate. (H)
ƒ Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module.(I)
ƒ Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack) into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (J)


A B
C
D
E F