20
Tank(Sediment)Cleaning
the drain valve and allowing two gallons of water to drain from
the heater. The inlet water valve should remain open to maintain
these cases one or both of the following methods may be used
NOTE:Theknobcannotbe
turnedfrom“PILOT”to“OFF”unlessknobisdepressed
slightly.DONOTFORCE.
2. Drain the heater by following the steps in the Draining section
of this manual.
plate and remove the plate.
the glass lining.
Center with the appropriate part number from the Parts
Order List in this manual.
7. Install the cleanout plate. Be sure to tighten the screws
8. Fill the heater with water by following the steps in the Filling
the Water Heater
cleanout plate.
10. Follow the lighting instructions in the Operating Instructions
section.
the sediment deposits. This may be ordered from the
Parts Order
List section of this manual.
VentSystemInspection
At least once a year a visual inspection should be made of the
Be sure the vent piping is properly connected to prevent
asphyxiation.
Obstructions and deteriorated vent systems may present serious
if air for combustion contains certain chemical vapors. Spray can
compounds which are potentially corrosive.
If when inspecting the vent system you find sooting or
before resuming operation of the water heater.
BurnerInspection
Flood damage to a water heater may not be readily visible
water heater. Do not attempt to repair the unit! It must be
replaced!
At least once a year a visual inspection should be made of the
proper combustion.
Soot build-up indicates a problem that requires correction
SERVICE AND ADJUSTMENT