MAINTENANCE
Reel Drive Belts
To replace The Reel Drive Belts. Reels 8 and 9.
• Remove the Sheave Guard.
• Remove the Safety Chain at the Stay Rod.
• Compress the Telescopic Arm. Refer to Fig.33
• Remove the Belt from the Sheaves.
• Release the Compression Tool to fully expand the
Telescopic Arm.
• Pull the Reel ‘out,’ to separate the Telescopic Arm,
and remove the Belt.
• Install a new Drive Belt and re-assemble in the
reverse order.
To replace the Reel Drive Belts. Reels 10 and 11.
• Remove the Bearing Cover
• Remove the Set Screw from ‘outer’ end of the PTO
Shaft, and slide it off the Jackshaft.
• Compress the Telescopic Arm. Refer to Fig.33.
• Install a new Drive Belt and re-assemble in the
reverse order.
IMPORTANT
Apply ‘Loctite 242’ to the PTO Shaft Setscrews.
Fig.36
Fig.37 40
