MAINTENANCE WORK ON CHASSIS AND ENGINE 83
200114-10
– Pull the oil filter insert out of the oil filter casing.
Circlip pliers reverse (51012011000)
– Completely drain the engine oil.
– Thoroughly clean parts and sealing surface.
9.107Installing the oil filter x
200114-11
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
– Fill the oil filter with engine oil and place it in the oil filter container.
– Lubricate the O/ring of the oil filter cover.
200113-11
– Refit the oil filter cover .
– Mount and tighten screws .
Guideline
Screw, oil filter cover M6 10 Nm (7.4 lbf ft)
– Stand the motorcycle upright.
9.108Filling up with engine oil x
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
200115-10
– Remove the screw cap on the generator cover and fill up with engine oil.
Engine oil (1st
partial quantity
approx.)
0.35 l (0.37 qt.) Engine oil (SAE 10W/50) ( p. 105)
– Mount and tighten the screw connection on the generator cover.
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
– Start the engine and let it run idle for 30 seconds.
– Stop the engine and check that it is oil-tight.
