A SERVICE OF

logo

9
English
4. Slide the rail with the feeder mounted back toward the printer
until the connector on the front side of the feeder is fully
connected to the connector on the base, holding the feeder by
the both hands.
When mounting the feeder to the printer, be
careful to avoid pinching your fingers between
the two.
Do not use the adjuster knob on the top of the
feeder or the feeder plastic cover as a handle
for sliding the feeder.
Make sure that the connector of the bulk paper feeder is
properly aligned with the connector on the front side of the
printer base unit.
This completes setting up the feeder with the printer. Before using the
feeder, plug the printer to power and load paper in the bulk paper
feeder (explained in the following pages).
Rail
Plastic Cover
Adjuster Knob
Bulk Paper Feeder
Connector
Option Feeder
Slot
pf8-Eng.pm6 12/19/00, 8:22 PM9