IMPORTANT SAFETY INSTRUCTIONS - READ CAREFULLY BEFORE USE.
This symbol indicates that there are important operating maintenance instructions in the user manual accompanying this unit.
This symbol indicates that dangerous voltage is present within this unit constituting a risk of electric shock or personal injury.
CAUTION: TO PREVENT ELECTRICAL SHOCK, DO NOT REMOVE ANY
COVER SCREWS. THERE ARE NO USER SERVICEABLE
PARTS INSIDE. REQUEST A QUALIFIED SERVICE PERSON TO PERFORM SERVICING.
Keep these instructions in mind:
Clean only with a slightly damp cloth.
Do not cover or block any ventilation openings. When placing on a shelf leave 5 cm (2”) free space around the whole unit.
Protect the power cord from being walked on or pinched, particularly at plugs, and
the point where it exits the unit. Do not place heavy
items on the power cord, which may damage it. Take note that the power cord cannot be reached and pulled by young children, a
voiding
injury.
Unplug this unit during lightning storms or when unused for a long period of time.
Keep the unit away from heat sources such as radiators, heaters, stoves, candles and other heat
-generating products.
WARNING! NEVER INSERT AN OBJECT INTO THE PRODUCT THROUGH VENTS OR OPENINGS. HIGH VOLTAGE FLOWS IN THE
PRODUCT AND INSERTING AN OBJECT CAN CAUSE ELECTRIC SHOCK AND/OR SHORT INTERNAL PARTS. FOR THE SAME
REASON, DO NOT SPILL WATER OR LIQUID ON THE PRODUCT.
Do not use this unit near water.
Do NOT use in wet or moist areas such as bathrooms, steamy kitchens or near swimmin
g pools.
Do not use this unit when moisture condensation may occur.
NOTE: No naked flames such as candles should be placed on the radio.
This unit has been produced according to all current safety regulations. The following safety tips should safeguard use
rs against careless use
and the dangers connected with such use.
Although this unit has been carefully manufactured and rigorously checked before leaving the factory, as with all electrical
appliances, it is
possible for problems to develop. If you notice smoke, an excessive build up of heat or any other unexpected phenomena, you should
disconnect the plug from the mains power socket immediately.
This unit is a class II device. It does not require a grounded connection.
Ensure that the unit is sufficiently ventilated!
The mains plug or appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
This unit must operate on a power source specified on the specification label. If you are not sure of the type of
power supply used in your
home, consult your dealer or local power company.
The socket outlet must be installed near the equipment and must be easily accessible.
Do not overload AC outlets or extension cords. Overloading can cause fire or electric shock.
Keep away from rodents. Rodents enjoy biting into power cords.
Always hold the plug when pulling out the plug from the mains supply socket. Do not pull the power cord. This can cause a sho
rt circuit.
Avoid placing the unit on any surface, which may be subject to vibrations or shocks.
When the unit is not used for long periods of time, unplug the AC power cable for safety reasons.
To clean the unit, use a soft dry cloth. Do NOT use solvents or petrol based fluids. For stubborn stains, you may use a damp
cloth with
dilute detergent.
When the unit will not be used for a longer period of time, remove the batteries to avoid damage which can be caused by batte
ry leakage
or corrosion.
Declaration of Conformity
Products with the CE marking comply with the EMC Directive (2004/108/EC) and the Low Voltage Directive (2006/95/EC) issued by
the Commission of the European Community.
This symbol indicates that the relevant electrical product or battery should not be disposed of as general household waste in
Europe.
To ensure the correct waste treatment of the product and battery, please dispose them in accordance to any applicable local laws
of
requirement for disposal of electrical equipment or batteries. In so doing, you will help to conserve natural resources and i
mprove
standards of environmental protection in treatment and disposal of electrical waste (Waste Electrical and Electronic Equipmen
t Directive).
For information and support; www.lenco.eu
Lenco helpdesk:
Germany 0900-1520530 (Local charges)
The Netherlands 0900-23553626 (Local charges + 1ct P/min)
Belgium 02-6200115 (Local charges)
France 0170480005 (Local charges)
The helpdesk is accessible from Monday till Friday from 9 AM till 6 PM.
In case your device needs repair our helpdesk will redirect you to your local dealer.
Lenco offers service and warranty in accordance to European law, which means that in case of repair (both during and after th
e warranty
period), you should contact your local dealer. Please note: It is not possible to send repairs to Lenco directly.
Important note: If the unit is opened by a non-official service center the warranty expires.
Where to install?
Locate the unit away from direct sunlight, soft indirect lighting is recommended for comfortable viewing. Place the unit on a
sturdy platform of
which the surface should be flat. This will prevent it from falling over. Make sure the unit is located in a position where i
t cannot be pushed or
hit by objects, as pressure will break or damage the unit, and so that small objects cannot be in
serted into the ventilation slots or openings in
the cabinet.
