61
Mac OS 8.6 to 9.x Step 1: Install a custom PPD file
Note: Installing the custom
PPD is required only if this is
the first time the printer has
been set up. If the printer
was previously installed, go
on to “Step 2: Create a
desktop printer” on page 61.
1 Insert the drivers CD into your CD-ROM drive.
2 Double-click Classic.
3 Double-click the Lexmark Installer icon.
4 Select the language of your operating system, and then click
OK.
5 Click Install to install the PPD file for your printer.
Step 2: Create a desktop printer
1 In the Chooser, select the LaserWriter 8 driver.
2 If you have a routed network, select the default zone from the
list. If you don’t know which zone to select, look on the Network
Setup page under AppleTalk for Zone.
3 Select the new printer from the list.
4 If you don’t know which printer to select, look on the Network
Setup page under the AppleTalk heading to find the default
name of the printer.
5 Click Create.
6 Make sure there is an icon next to the printer name in the
Chooser.
7 Close the Chooser window.
8 Verify printer installation.
a Click the desktop printer icon you just created.
b Choose Printing Change Setup.
• If the PPD file displayed in the PostScript Printer
Description (PPD) file portion of the menu is correct for
your printer, printer setup is complete.
• If the PPD file displayed in the PostScript Printer
Description (PPD) file portion of the menu is not correct
for your printer, repeat “Step 1: Install a custom PPD file”
on page 62.
