13
10
4
8
F
8
4. Locate the TELEMETRY CABLE (#15). Feed the 3-PIN
CONNECTOR (3P) end of the cable through the front of the
HANDLEBAR ASSEMBLY (#13). The cable must be routed down
the HANDLEBAR BRACKET TUBE (F) and back up the top of the
MONOCOLUMN (#10). Feed the 3-PIN CONNECTOR through the
DISPLAY CONSOLE MOUNTING BRACKET (D) ACCESS HOLE.
5. Secure the HANDLEBAR ASSEMBLY (#13) to the HANDLEBAR
BRACKET TUBE (F) using six MOUNTING SCREWS (#4).
Tighten the SCREWS securely.
6. Locate the POLAR RECEIVER ASSEMBLY (#14). Plug the
POLAR RECEIVER ASSEMBLY into the POLAR RECEIVER
JACK (J). Place the POLAR RECEIVER in a vertical position,
POLAR RECEIVER JACK facing downward, at the front of the
HANDLEBAR BRACKET TUBE (F). Position the POLAR COVER
(#6) over the center of the HANDLEBAR ASSEMBLY (#13) at the
HANDLEBAR BRACKET TUBE. Making sure the POLAR COVER
is oriented properly, slide the POLAR COVER over the
HANDLEBAR ASSEMBLY covering the POLAR RECEIVER
ASSEMBLY and the end of the HANDLEBAR BRACKET TUBE.
The POLAR COVER should fully nest over the HANDLEBAR
ASSEMBLY. Secure the POLAR COVER using two MOUNTING
SCREWS (#8).
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS PAN HEAD
SCREWS (#8).
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES
VIS CRUCIFORMES À TÊTE CYLINDRIQUE (Nº 8).
10
13
F
D
