Lifetime #7525 Manual

next previous

HD9185

Required For This Page:

(3)

3/4” Wrenches

(3)

1/2” Socket Wrench

Hammer/Mallet

Electric Drill

32.1 Remove the plastic lm from the

Backboard.

32.2 Use an electric drill to

insert the Screws (FA).

(10)

HH00700

35.1 Place a 1/2” x 1/8” Spacer (MN) between each Short

Extension Arm (AA) and the pole.

35.2 Completely tighten the Nuts

from steps 32 through 34.

Note: The Rear Lifter Arms (AR) must be on the inside of the Extension Arms (AE).

33.2 Only nger tighten the Nut.

33.1 Lift the pole up until the Long Extension Arms (AE) line up with the holes

in the Rear Lifter Arms (AR).

34.1 There must be a 1/2” x 1/8” Spacer (MN)

between each Long Extension Arm (AE) and the

pole.

AE AE

34.2 Only nger

tighten the Nut.

(4)

(1)