7
SECTION 3: KNOW YOUR LOG SPLITTER
Compare the illustration in Figure 7 below with the controls on your log splitter, and get familiar with its features
before starting to operate. Know how to stop the machine quickly in the event of an emergency.
Figure 7
Control Handle
The control handle has three positions. See Figure 7.
• FORWARD: Move control handle FORWARD or
DOWN to move wedge to split wood.
NOTE: Control handle will return to neutral position as
soon as handle is released.(Forward Position only)
• NEUTRAL: Release the control handle or move
the lever to neutral position to stop the wedge
movement.
• REVERSE: Move control handle BACK or UP to
return the wedge toward the cylinder. The control
handle stays in the return (Reverse) position and
returns to neutral automatically when fully
retracted.
NOTE: Reverse position may also be operated back to
neutral position manually, if necessary.
Beam Locks
These two locks, as their name suggests, are used to
secure the beam in the horizontal or the vertical
position. The vertical beam lock is located next to the oil
filter. The horizontal beam lock is located on the beam
support latch bracket. See Figure 7.
Engine Controls
See the accompanying engine manual for the location
and function of the controls on the engine.
Stopping Engine
• Move throttle control lever to STOP or OFF
position.
• Turn off the engine switch, if so equipped.
• Disconnect spark plug wire and ground against the
engine to prevent unintended starting.
IMPORTANT:
Your log splitter is shipped with motor oil in
the engine. However, you MUST check the oil level
before operating. Be careful not to overfill.
Horizontal
Control Handle
Reservoir
Vertical Beam Lock
Jack Stand
Beam Assembly
Cylinder
Log Cradle
Beam Lock
Vertical
Beam Lock
Tongue
Horizontal
Beam Lock
Wedge
Hitch
Assembly
Tank
Fender*
*If Equipped
Control
Handle
To split
To stop
wedge
Forward
Neutral
Reverse
How it works
(Automatic)
wedge
(Manual)
wood
To return
Log
Dislodger
