Index
© National Instruments Corporation I-5 GPIB-ENET/100 for Mac OS
resetting default network characteristics, 6-4
restarting
after using NI-488 Config utility, 4-3
S
software
configuring NI-488.2, 4-1
installation, 2-1
overview, 1-4
transfer rate (maximum), C-2
verification test, 5-1
specifications
electrical characteristics, C-1
environmental characteristics, C-1
network specifications, C-2
physical characteristics, C-1
software characteristics, C-2
static IP parameters
assigning, 3-6
choosing static IP address, 3-6
using instead of DHCP, 3-8
when easier than using DNS, 6-2
status code number
recording, A-2
subnet mask
purpose, 3-6
selecting valid IP addresses for, 3-7
system integration, D-1
T
technical support resources, D-1
timeout problems
fixing, B-5
troubleshooting
hardware problems, B-1
software problems, B-1
U
universal power supply
connecting, 2-3
updating the firmware, 6-4
using
CFG RESET switch, 6-2
DHCP, 6-1
Ethernet Device Configuration utility, 3-2
Ethernet Device Firmware Update
utility, 6-4
IBIC 488.2 utility, 6-6
Internet, 1-3
NI-488 Config, 4-1
NI-488.2 Test, 5-1
V
verifying
hardware installation, B-1
hostname, 3-8
software installation, 5-1
virus protection software
disabling before installing software, 2-1
voltage rating, C-1
W
warning
using firmware update utility, 6-4
Web support, D-1
worldwide technical support, D-2
