14
Top Paper Exit
During normal operation paper will exit through the top of the
printer, face down. To facilitate this there is a small paper support
set in to the printer cover.
1. Carefully pull this support (1) to the upright position and
extend the small plastic tab (2).
Manual Paper Feed
At the front of the printer, underneath the front panel, you will
see a pull down panel.
1. Carefully pull the tab (1) until the panel is in the fully
lowered position.
Paper will now be supported by this extension and not
block access to the printer front panel.
2. Swing the paper support extension (2) out until it forms
an even platform for the paper.
1
2
3. Extend the small plastic support arm (3) until it clicks
into place.
The manual feed slot is now ready to receive manually
fed paper.
Note: To use pre-printed stationery, feed face up, top first.
1
3
2
16n_gbR.pm6 16/09/96, 17:3114
