22
Turning On the CD/HDD Receiver
Tip:
When you start playback on (or turn on) an Onkyo RI Dock, CD recorder, MD recorder, or cassette deck that’s connected to
the CD/HDD receiver with an cable and analog audio cable, the CD/HDD receiver turns on automatically. Similarly, when
you set the CD/HDD receiver to On or Standby, the other component will also be set to On or Standby.
1
Plug the power cord into a suitable wall outlet.
The STANDBY indicator lights up after a while (several seconds). The CD/HDD receiver
enters the Standby mode.
Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the CD/HDD receiver may cause a momentary power surge that might interfere with
other electrical equipment on the same circuit. If this is a problem, plug the CD/HDD receiver into
a different branch circuit.
2
Press the [ON/STANDBY] button on the CD/HDD receiver or remote controller.
The STANDBY indicator goes off and the following screen appears on the display. Press the
[ON/STANDBY] button again to set the CD/HDD receiver to Standby. The STANDBY indi-
cator lights up.
To wall outlet
Power cord
(Plug type varies from country
to country.)
ON/STANDBYON/STANDBY
STANDBY indicator
