36
Zone 2—Continued
If you have connected your Zone 2 speakers to an amp
with no volume control, set the Zone 2 Out setting to
Variable so that you can set the zone’s volume, balance,
and tone on the receiver.
Zone 2 Out Settings
1
Press the [RECEIVER] Remote
Mode button, followed by the
[SETUP] button.
The setup menu appears on the display.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Hardware
set,” and then press [ENTER].
The Hardware Setup menu appears.
RECEIVER
SET UP
/
ENTER
//
3
Use the Up and Down [ ]/[ ]
buttons to select “Z2 Out: Fixed.”
4
Use the Left and Right [ ]/[ ]
buttons to select:
Fixed: The Zone 2 volume must be
set on the amp in that zone.
Variable: The Zone 2 volume can be
set on the receiver.
5
Press the [SETUP] button.
Setup closes.
