Advanced Settings (Setup Menu)
En-39
Power Management
Setting Item Default Value Setting Details
Sleep Timer Off Select to turn the unit into standby mode
automatically when the specified time elapses.
Select a value between "10 min" to "90 min".
"Off": Select if you do not want the unit to
automatically switch to standby.
Auto Standby On/Off This setting places the unit on standby
automatically after 20 minutes of inactivity
without any video or audio input.
"On": The unit will automatically enter standby
mode ("ASb" will light).
"Off": The unit will not automatically enter
standby mode.
● "Auto Standby" is appeared on the display
and TV screen 30 seconds before the Auto
Standby comes on.
● "Auto Standby" does not work when Zone 2
is active.
● Default values vary depending on the
regions.
Auto Standby in
HDMI Standby
Through
Off Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
● This setting cannot be set to "On" if "Auto
Standby" is set to "Off".
USB Power Out at
Standby
Off When this function is "On", you can still have
equipment connected to the USB port supplied
with power even when this unit is in standby.
● When this function is being used, the power
consumption increases even when the unit
is on standby. However, the increase in
power consumption is kept to a minimum
by automatically entering the HYBRID
STANDBY mode, where only the essential
circuit is operating.
Setting Item Default Value Setting Details
Network Standby Off When this function is "On", you can turn on
the power of the unit via network using an
application such as Onkyo Remote.
● When "Network Standby" is used, the power
consumption increases even when the unit
is on standby. However, the increase in
power consumption is kept to a minimum
by automatically entering the HYBRID
STANDBY mode, where only the essential
circuit is operating.
Bluetooth Wakeup Off
This function wakes up the unit on standby by
connecting a Bluetooth-enabled device.
"On": Use this function
"Off": Do not use this function
● Setting to "On" increases the power
consumption even when the unit is on
standby. However, the increase in power
consumption is kept to a minimum by
automatically entering the HYBRID
STANDBY mode, where only the essential
circuit is operating.
● This setting is fixed to "Off" if "Bluetooth" -
"Auto Input Change" is set to "Off".
● Wait for a while if "Network Standby" or "Bluetooth Wakeup" cannot be selected. It will appear when
the network function is started up.
