51
First Time Setup
This section explains the settings that you need to make before using the AV receiver for the very first time.
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
Speaker Type setting. For hookup information, see pages
27–30.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 2.1 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
Speaker Settings
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
INPUT SELECTOR
DISPLAY MUTING
G
U
I
D
E
E
X
I
T
PREV
CH
DIMMER
CDR/MD/DOCK
SAT
TAPE/AMP
SLEEP
MACRO
REMOTE MODE
--
/
---
10 11 12
TV CH
TV VOL
PLAYLIST
RANDOM
AUX1 AUX
2
GAME/TV
D. TUN
CD
TUNER
TAPE
PHONO
REC
ENTER
T
O
P
M
E
N
U
M
E
N
U
VOL
CH
DISC
ALBUM
TV
VCR
CABLE
NET/USB
DVD
RECEIVER
CD
-
123
ZONE
3
ZONE
2
+
-
+10
0
CLEAR
456
789
S
E
T
U
P
R
E
T
U
R
N
NET/USB
SP A SP B
2, 3
2–5
1
1, 6
If you change these settings, you must run the auto-
matic speaker setup again (see page 61).
RECEIVER
S
E
T
U
P
ENTER
ENTER
3
Use the Up and Down [ ]/[ ]
buttons to select “1. Speaker Set-
tings,” and then press [ENTER].
The Speaker Settings menu appears.
4
Use the Up and Down [ ]/[ ]
buttons to select “Speaker
Impedance,” and use the Left and
Right [ ]/[ ] buttons to select:
4 ohms:
Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms:
Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [ ]/[ ]
buttons to select “Front (Speaker
A),” and use the Left and Right
[ ]/[ ] buttons to select:
Normal:
Select this if you’ve con-
nected your front Speakers A
normally.
Bi-Amp:
Select this if you’ve con-
nected your front Speakers A
for bi-amped operation.
BTL:
Select this if you’ve con-
nected your front Speakers A
for bridged operation. The
BTL indicator will appear on
the display.
Note:
• Bi-Amp and BTL cannot be selected
if Front (Speaker B) is set to Bi-Amp
or BTL.
ENTER
ENTER
2-1.Speaker Settings
Speaker Impedance
6ohms
Front(Speaker A) Normal
Front(Speaker B) Not use
ENTER
ENTER
