65
Specifi cations
TH-85PF12E
Power Source 220 - 240 V AC, 50/60 Hz
Power Consumption
Power on 1,100 W
Stand-by condition Save off 1.2 W, Save on 0.7 W
Power off condition 0.4 W
Plasma Display panel Drive method : AC type
85-inch, 16:9 aspect ratio
Screen size 1,889 mm (W) × 1,062 mm (H) × 2,167 mm (diagonal)
(No.of pixels) 2,073,600 (1,920 (W) ×1,080 (H))
[5,760 × 1,080 dots]
Operating condition
Temperature 0 °C - 40 °C
Humidity 20 % - 80 %
Applicable signals
Scanning format 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 750 (720) / 60p · 50p, 1125 (1080) / 60i · 60p · 50i ·
50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50i
PC signals VGA, SVGA, XGA, SXGA
UXGA ···· (compressed)
Horizontal scanning frequency 15 - 110 kHz
Vertical scanning frequency 48 - 120 Hz
Connection terminals
DVI-D IN Video Input
Audio Input
Content Protection
DVI-D 24 Pin × 1
compliance with DVI Revision 1.0
* Refer to page 11 for applicable signals
Stereo mini jack (M3) × 1
0.5 Vrms
Compatible with HDCP 1.1
LAN RJ45 10BASE-T/100BASE-TX, compatible with PJLink™
COMPONENT/RGB IN Y/G (BNC)
P
B/B (BNC), PR/R (BNC)
Audio Input
with sync 1.0 Vp-p (75 Ω)
0.7 Vp-p (75 Ω)
Stereo mini jack (M3) × 1
0.5 Vrms
PC IN (HIGH-DENSITY MINI D-SUB 15PIN)
B/P
B/CB:
R/P
R/CR:
HD/VD:
VBS (use HD port)
Audio Input
Y or G with sync 1.0 Vp-p (75 Ω)
Y or G without sync 0.7 Vp-p (75 Ω)
0.7 Vp-p (75 Ω)
0.7 Vp-p (75 Ω)
1.0 - 5.0 Vp-p (high impedance)
with picture 1.0 Vp-p (high impedance)
without picture 0.3 Vp-p (high impedance)
Stereo mini jack (M3) × 1
0.5 Vrms
SERIAL EXTERNAL CONTROL TERMINAL (D-SUB 9PIN) RS-232C COMPATIBLE
AUDIO OUT RCA PIN JACK × 2 (L / R)
OUTPUT LEVEL : VARIABLE (-
∞
~ 0 dB) [INPUT 1 kHz / 0 dB, 10 kΩ Load]
Accessories Supplied
Remote Control Transmitter
EUR7636090R
Batteries R6 Size × 2
Fixing band TMME203 × 2
Ferrite core J0KG00000014 × 2
Noise cut fi lter TXZDM011MBE
Clamper TMM15412-2 × 1
Dimensions (W × H × D) 2,015 mm × 1,195 mm × 99 mm
Mass (weight) approx. 117.0 kg net
Notes:
• Design and specifi cations are subject to change without notice. Mass and dimensions shown are approximate.
• This equipment complies with the EMC standards listed below.
EN55022, EN55024, EN61000-3-2, EN61000-3-3.
