11
Table 6. General Management Configuration Options (2 of 2)
Option Comments/DescriptionFactory 2Factory 1
Edit Edit
The Subnet Mask needed to
access the device when the COM
Com NetMask:
Clear Clear
access the device when the COM
port is configured for SNMP.
PPP PPP
The link layer protocol for the COM
Com Link:
SLIP SLIP
port when configured for SNMP.
Enable Enable
Specifies whether the device is the
IPBusMast:
Disab Disab
IP Bus Master.
None None
IPBus IPBus
The default networkconnection
Def Netwk:
Com Com
The default network connection.
FDL FDL
Table 7. Management Trap Configuration Options (1 of 2)
Option Factory 1 Factory 2 Comments/Description
Num Trap Mgrs:
1
2–6
1
2–6
The number of trap managers
supported by the device.
Edit Edit
Specifies the IP address for each
trap manager. This configuration
Trap
n
IP Adr:
Clear Clear
.
option is repeated for all
n
managers.
None None
Tra
n
Dst:
IPBus IPBus
S
ecifies the network destination
rap
n
s
:
Com Com
pec
es
e ne
wor
es
na
on
for Trap Manager
n
.
FDL FDL
Disab Disab
Warm Warm Specifies the general trap types to
enable: WarmStart Authentication
Gen Trap:
Auth Auth
enable: WarmStart, Authentication
Failure or both.
Both Both
.
Enab Enab
Specifies whether the
EnterpriseSpecific trap type is
Entp Trap:
Disab Disab
EnterpriseSpecific trap type is
enabled.
