A. Configuration Options
8784-A2-GB20-30 February 2001
A-7
Copy Ports Options
You can copy the configuration options of one DSX-1 interface and DSL loop to
another using the Copy Ports screen. For Copy Ports options, refer to Table A-3,
Copy Ports Options. To access the Copy Ports screen, follow this menu selection
sequence:
Main Menu
→
Configuration
→
Current Configuration
→
Copy Ports
Table A-3. Copy Ports Options
From: Port
n
Possible Settings:
1
,
2
Default Setting:
1
Controls the source of the configuration options.
1
to
2
– The configuration of the selected port is copied.
To: Port
y
Possible Settings:
1
,
2
,
All
Default Setting:
2
Controls the target of the configuration options.
1
to
2
– The configuration of the selected port is replaced. If Perform Copy Then
Increment is selected, the port number is incremented by 1 after the copy.
All
– The configurations of all ports are replaced by the configuration of the selected
From: Port.
NOTE: Peer IP Address and Circuit Identifier are
not
copied.
main/config/copy Hotwire
Slot 4 Model: 8784
COPY PORTS
From: Port 1:
To: Port 2:
Perform Copy
Perform Copy Then Increment
--------------------------------------------------------------------------------
ESC for previous menu MainMenu Exit
Save
