C2
-- Vour television comes with an
I onscreen clock. During normal
operation the clock appears on the
screen when the STATUS/EXIT but-
ton is pressed or when channel
changes occur
<_ Press the CLOCK button on
the remote to display the onscreen
CLOCK menu.
<_;_ Press the CURSOR UP • OR
CURSOR DOWN • buttons until
the words SET CLOCK are high-
ghted,
<_ Enter the current time using
the NUMBERED buttons. If the
first number is a single digit first
enter a zero then the di,g,lt (i.e.,
press "0 , then press 8 ).
@Press the CURSOR RIGHT •
or CURSOR LEVI" • buttons to
set either AM or PM time.
Note: The CLOCK onscreen menu
can also be accessed through the
main menu by pressing the MENU
button; then scrolling up/down
with the CURSOR UP • or
CURSOR DOWN • buttons until
the word CLOCK is highlighted.
Press the CURSOR RIGHT •
button to activate the CLOCK
menu and follow the steps above to
set the time.
@
Remember: Be sure to
tli press "0" first and then the
hour number for single digit
entries.
To clear the onscreen menu press
the STATUS/EXIT button or wait a
few seconds after you have finished
your adjustment and the menu will
automatically disappear from the
screen.
[SETOJXX
qlMER ACTIVE ON
CHANNEL 12
ISETCt_0CK 10:00 AMI
TIMERACTME ON
CHANNEL 12
Note: If a power failure occurs, the
TVts CLOCK will have to be reset.
If no time is set, the time will not
appear oascreen.
•tram _m
©©
lotto _
Note: The CLOCK onscreen menu can
also be accessed throughthe main menu
by pressing the MENU button; then
scrolling up/down with the CURSOR
UP • or CURSOR DOWN • buttons
until theword CLOCK is highlighted.
Press the CURSOR RIGHT • button
to activatethe CLOCK menuand follow
the steps above to set the time.
18
