For UHF reception, position the
dipoles as shown**
For channels 14 through 69, rotate and/or tilt
the center loop towards the transmitter.
Using the selector switch
Choose your signal source by switching
from ANTENNA to CABLE.
Note that in the CABLE position,
1 LED lamp will illuminate.
Fine-tune the picture
Slowly increase the gain until you achieve the
clearest picture possible. Rarely, it is necessary
to use the maximum gain.Too much gain may
result in poor picture quality.
The manufacturer warrants that this product shall be free from defects in material,workmanship and
assembly,under normal use,in accordance with the specifications and warnings,for as long as you own
this product.This warranty extends only to the original purchaser of the product,and is not transfer-
able.Defective products,together with the dated proof of purchase,must be returned to the place of
purchase for repair or replacement.THERE ARE NO OTHER EXPRESS WARRANTIES. Incidental and
consequential damages are disclaimed where permitted by law. This warranty gives you specific legal
rights,and you may also have other rights which vary from state to state.
Table des matières
Contenu de la boîte
Table des
matières
